Az oldalunk használhatóságának érdekében sütiket (cookie) használ, amelyek leírását az adatvédelmi tájékoztatónkban találod. Rendben
PREMIUM TUNING
AKCIÓK! HÍREK
ACL főtengely csapágy készlet BMW B58B30
ACL főtengely csapágy készlet BMW B58B30
- 15%
Kattintásra galéria nyílik
232,90 USD     197,97 USD
Áfával Áfa nélkül
Tedd a kosárba!
A bruttó ár (Áfával) 0% áfát tartalmaz, amennyiben a postázási vagy átadási ország: United States
Választék
Alapméret 197,97 USD
0.025 extra clearance 197,97 USD
0.025 oversize 197,97 USD
Gyártó

Gyári cikkszám: 7M1512H-.025

Rendelésre!
A kiszállítás várható napja:
2024.12.30
ACL főtengely csapágy készlet BMW B58B30

MAIN BEARING SET - STD, .025, .25
High performance Trimetal engine bearings
Designed to withstand higher RPM conditions
High strength overlay plate with reduced thickness for improved fatigue properties

Specifications:

Size: STD, .025, .25
Oil Clearance: Standard
Half Type: Identical Halves
Material: Tri-metal Hardened steel backs
Min Std Shaft Size: 1.9281in / 48.975mm
Max Std Shaft Size: 1.9288in / 48.991mm
Min Std Tunnel Size: 2.0866in / 53.000mm
Max Std Tunnel Size: 2.0872in / 53.015mm
Max Wall at Crown: Std: 0.0785in / 1.993mm
Max Overall Length: 0.630in / 16.00mm
 

Other Part Numbers:
ACL 6B1510H-STD

M140i, M240i, 340i, M340i, 440i, 540i, Supra A90

When doing rods and pistons, it’s a good idea to replace the rod bearings as well. ACL’s high-quality rod bearings will prevent fatigue, failure, and reduce drivetrain stress through their durable and strong design.

Race series bearing features:
Designed to withstand higher RPM conditions.
High strength overlay plate with reduced thickness for improved fatigue properties.
Hardened steel backs on all rod bearings to improve the support of the bearing lining and assist with bearing retention in the housing.
Increased crush for improved bearing retention.
Elimination of flash plating on the back of the bearings to improve heat transfer through the bearing sand to maximize the grip between the bearings and its housing.
Increased eccentricity to compensate for bore distortion at high rpm and to assist in the formation of hydrodynamic oil films.
3/4 grooved Main Bearings to optimize bearing load carrying surface area and oil flow to the conrod bearings.
Tight consistent wall tolerances to help you maintain consistent clearances.
Enlarged ID chamfers on bearing edges where required to accommodate large fillet radius on performance crankshafts.
Értékelések átlaga

Nincs értékelés